LDARtools phx42 - Application Error Codes

23
Application Error Codes
If the application you are using with the phx42 gives an error code, this is what your machine is trying
to say:
R*(.!
H.&53$:%$*#!
L!
,**!C1#B!517$N31%$*#!:*$#%&9!
X[!
\B!271C.!$&!*+%9!
XM!
,-$&!1::7$51%$*#!21$7.(!%*!&.%!%-.!(1%.!1#(!%$C.9!G!3.177B!7$V.!%*!V#*6!1%!7.1&%!]I^8!G!1C_!
XZ!
,-$&!517$N31%$*#!51##*%!N.!(.7.%.(9!R*#%15%!TH'U%**7&!J+::*3%9!
4E!
,-$&!517$N31%$*#!51##*%!N.!:*&&$N7.9!G`C!3.1($#;!%-$&!&$;#17!7*6.3!%-1#!%-.!71&%!;1&!B*+!1::7$.(9!
4X!
8*!51#!(*9!G!#..(!&*C.!613C$#;!+:!2$3&%9!H.:.#($#;!*#!B*+3!1::7$51%$*#!B*+!C1B!#..(!%*!
613C!C.!+:!2*3!7*#;.3!%-1#!%-$&!&-*3%!3.a+$3.C.#%9!
44!
G!51#`%!3+#!*#!I4!%-$&!7*6_!
4>!
Remove probe tip filter, wait 5 seconds, then reinstall the same filter.
FAQ
What%should%I%do%if%I%receive%an%Intake%Overpressure%Error,%but%my%filter%has%not%
been%removed?%
G2!B*+!3.5.$F.!1!0'TJ^!$#%1V.!*F.3:3.&&+3.!.33*3b!
6. Add a Second filter to your probe tip.
7. Reignite using your monitoring software.
8. Once successfully ignited, remove ALL filters from your probe tip.
,-$&!6$77!:+%!%-.!:-?>4!$#%*!&7..:!C*(.!1#(!B*+!6$77!3.5.$F.!1#!cG#%1V.!
/F.3:3.&&+3.”!C.&&1;.9!
9. Add one filter to your probe tip.
10. Reignite using your monitoring software.