Safety and Equipment Protection
PHOTON
+
System Guide 8
Danger Warnings
The warning messages below, and throughout this guide, are important
notices regarding safe system operation and system protection.
Instructions given by these warning must be followed to ensure safety for
both personnel and equipment.
Warning
Dangerous voltages may be present in the system.
Use the same care as you would for any electronics
equipment when handling, calibrating, or maintaining
this system.
Warning
Under no circumstances should an operator remove
any covers, screws, or in any way enter the
PHOTON+
System. There are no operator settable controls or
adjustments inside the
PHOTON+.
Warning
To prevent potential fire or shock hazard, do not
expose the system to rain or moisture.
Warning
Do not connect analog voltage signals exceeding
+
36 Volts to the input or tachometer channels or the
system electronics may be damaged.
Warning
Do not connect an analog voltage source to the output
channel or the system electronics may be damaged.
To Next Page
Loading...
Need help?
General
