Leadshine Technology CS-D1008E - Page 19

CS-D1008E Closed Loop Stepper Drive User Manual
Page | 15
Motor stalls during acceleration
Current setting is too small
Choose another power supply with lager
power or increase the output current of
drive
Motor is undersized for the application
Choose another motor with higher torque
Acceleration is set too high
Reduce the acceleration
Power supply voltage too low
Choose another power supply with large
voltage output
Excessive motor & drive heating
Inadequate heat sinking / cooling
Refer to chapter 2.4
Motor peak current setting is too high
Reduce the current value refer to motor
datasheet
Motor vibration when power on
Position loop Kp is too high
Reduce the position loop Kp value
Motor only one direction
DIR inputs is burned
Check whether S1 is set to 5V, while the
actual control signal is 24V
Mismatched pulse types
Check if SW7 is set incorrectly