Leadshine CS-D403 - Default Chapter; Table of Contents

CS-D403 Closed Loop Stepper Drive User Manual
Content Table
1. Introduction.......................................................................................................................................................................1
1.1 Features...................................................................................................................................................................1
1.2 Applications............................................................................................................................................................ 1
2. Specifications....................................................................................................................................................................2
2.1 Electrical Specifications......................................................................................................................................... 2
2.2 Environment............................................................................................................................................................2
2.3 Mechanical Specifications......................................................................................................................................3
2.4 Heat Dissipation......................................................................................................................................................3
3.1 Connector P1 – Control and Digital Output Connections......................................................................................4
3.1.1 Pin Assignments of P1.................................................................................................................................4
3.1.2 Typical Control and Fault Output Connections...........................................................................................6
3.2 Connector P2 - Encoder Connection...................................................................................................................... 7
3.3 Connector P3 - Motor Connection......................................................................................................................... 7
3.4 Connector P4 – Power Supply Connection............................................................................................................ 7
3.5 Connector P5 – RS232 Connection........................................................................................................................7
3.6 LED Light Indication..............................................................................................................................................8
4. Motor Selection.................................................................................................................................................................8
5. Power Supply Selection....................................................................................................................................................8
5.1 Regulated or Unregulated Power Supply............................................................................................................... 9
5.2 Power Supply Sharing............................................................................................................................................ 9
5.3 Selecting Supply Voltage........................................................................................................................................9
6. DIP Switch Configurations...............................................................................................................................................9
6.1 Microstep Resolution (SW1-SW4)...................................................................................................................... 10
6.2 Other DIP Switch Settings (SW5-SW8)...............................................................................................................10
7. Typical Connection......................................................................................................................................................... 10