Need help?Do you have a question about the Leadshine HBS86H and is the answer not in the manual?
Describes ALM and PEND signal output ports and their connections with diagrams.
Details the control signal input ports and their corresponding pin assignments.
Illustrates wiring connections to control signals using a common anode configuration.
Provides timing diagrams for PUL, DIR, and ENA signals to ensure correct operation.
Explains how the SW1 DIP switch configures the activate edge of input signals.
Troubleshooting steps for when the power light is off after power-on.
Diagnosing issues when the red alarm light is illuminated upon power-on.
Describes ALM and PEND signal output ports and their connections with diagrams.
Details the control signal input ports and their corresponding pin assignments.
Illustrates wiring connections to control signals using a common anode configuration.
Provides timing diagrams for PUL, DIR, and ENA signals to ensure correct operation.
Explains how the SW1 DIP switch configures the activate edge of input signals.
Troubleshooting steps for when the power light is off after power-on.
Diagnosing issues when the red alarm light is illuminated upon power-on.
General| Pulse Input Frequency | 0-200kHz |
|---|---|
| Control Method | Closed-loop Control |
| Protection Features | Over-voltage, Over-current |
| Baud Rate | 9600 bps |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to +70°C |
| Humidity | 5% to 95% (non-condensing) |
To Next Page
