________________________________________________________________________________________________
_______________________________________________________________________________________________
Operation Manual Page 19 of 27
Important Notice: If the pipe got in touch with drinking
water or foodstuff, use LEFON lubricating gel on saw
blade.
Important Notice: For non-stop operation, after cutting,
loosen the hexagon nut no top of saw blade to avoid
damage caused by tension.
_____________________________________________
Step 6: Switch on the machine. (Soft start takes 3
seconds to initiate due to protection design)
Step 7: Slowly turn the motor using the lower grip
handle (1) and top handle wheel (2) clockwise until the
wall of the pipe/tube has been pierced through with
three or four blade teeth visible.
Step 8: Keep turning, and increase the turning speed to
cut the pipe off
Step 9
: Switch off the motor.
To Next Page
Loading...
