________________________________________________________________________________________________
_______________________________________________________________________________________________
Operation Manual Page 24 of 27
Section 5: Maintenance & Troubling Shooting
Maintenance summary
Time Interval Action
Before starting machine
• Remove chips and dirt from the saw blade
• Keep the vent holes free of chips
Every cleaning,
Every blade change
• Don’t use pressurized air to clean, which would blow cuttings into machine to
compromise the accuracy of future use
• Use cloth or brush to clean the end of the shaft
Every week
• Clean and lubricate
- The spindle of the top handle wheel(1)
- The sliding block(2)
- The guide bush(3)
- The vice track(4)
- The vice spindle(5)
• Check the gear oil level and top up (refer to next pages)
To Next Page
Loading...
