What to do if the Lefon Saw motor is not running?
If the motor of your Lefon Saw isn't running, it could be due to the overload protection relay or the restart inhibitor being triggered. First, set the switch to off, wait about 15 minutes, and then switch the machine on again. If that doesn't work, set the switch to off and then switch the machine on again.
Why blade doesn’t cut and is slipping on Lefon R4?
If the blade of your Lefon Saw isn’t cutting and is slipping, it's likely that the hexagon nut on the saw blade shaft isn't tightened enough. You should tighten the hexagon nut.
What to do if pipe can’t be cut with Lefon R4 Saw?
If you can't cut the pipe with your Lefon Saw, the saw blade might be mounted incorrectly. Reverse the blade so that the labeled side faces outwards.
How to fix Lefon R4 Saw sliding housing that doesn’t turn?
If the sliding housing of your Lefon Saw doesn’t turn, it's probably because the pipe diameter isn't adjusted correctly. Adjust the top handle wheel correctly following the earlier instructions.
What to do if pipe diameter can’t be adjusted on Lefon Saw?
If the pipe diameter can’t be adjusted on your Lefon Saw, the slide guide might be dirty. Clean the slide guide following the earlier instructions.
General safety guidelines and precautions for operating the machine.
Critical safety information regarding electrical hazards and precautions.
Warnings and protective measures against injuries from sharp machine components.
Lists detailed technical parameters such as power, speed, voltage, and cutting range.
Guides on adjusting the machine for pipes of varying diameters and cutting/beveling operations.
Step-by-step guide for performing pipe cutting operations, including safety and lubrication.
Step-by-step guide for performing pipe beveling operations, including safety and lubrication.
Common issues, their causes, and recommended corrective actions for the machine.
To Next Page
General