________________________________________________________________________________________________
_______________________________________________________________________________________________
Operation Manual Page 14 of 27
Adjustment for different size pipe
Danger of being injured by rotating slide housing
When switching on the motor, the pipe cutter may
revolve around the pipe automatically.
• In their home position, the saw blade or beveling
cutter Must Not touch the pipe!
• Before switching on the motor, make sure the
gap between the saw blade/beveling cutter and
the pipe in sufficient.
Note: It is recommended to support pipe whose one end
is longer than 1 meter with supporting device or an
auxiliary place of deposit.
When only cutting blade installed
Step 1
: Adjust the top handle wheel (1) to make space
available for bigger size pipe.
Step 2: Clamp the pipe in place.
Step 3
: Grip the lower handle to turn the motor
clockwise for about 30° until the saw blade is in cutting
position
Step 4: Adjust the top handle wheel (1) until the teeth of
the saw blade (3) protrude about 1 to 2 mm inside the
pipe (2)
Note: scale of the hand wheel: a readjustment of one
graduation mark will result in a radial feed of bevel
alteration of 0.1mm.
To Next Page
Loading...
