LEGRAND FSIR-100 - HBP-111 Parameter Configuration and Actions; HBP-111 Prior, Send, and Save Operations

Next
Time Delay:
Sensitivity:
On Set point:
Burn-In Mode:
Walk-through:
Visual Alert:
SEND
<15 Mins>
<Max>
< Dis>
< Dis>
< Dis>
< Dis>
HBP-111 Settings
Press the Left/Right Arrow
to go to more settings
NEXT
Service Mode
HBP-111 Settings
Service Mode:
PRIOR SAVE
SEND
<Dis>
Press the Left/Right Arrow
to Enable or Disable
Occupancy Mode
To view more settings go to
NEXT and press the Select
button
Prior
HBP-111 Settings
Service Mode:
PRIOR SAVE
SEND
<Dis>
Press the
Down Arrow
to Choose PRIOR
Press
Select
To go back to previous
settings go to PRIOR and
press the Select button.
Save
Service Mode: <Dis>
PRIOR SAVE SEND
HBP-111 Settings
Press the
Down Arrow
to Choose SAVE
Profile 1
Profile 2
Profile 3
Profile 4
Profile 5
Profile 6
Cancel
Save HBP-111 Parms
Press
Select
Press
Select
Press the
Up/Down Arrow
to Choose Profile
Save FSP-211 Parms
Send
HBP-111 Settings
Service Mode:
PRIOR SAVE
SEND
<Dis>
Press the Down Arrow
to Choose SEND
To program the HBP-111
with the selected parameters
go to SEND and press the
Select button. The controlled
load should cycle once the
sensor is updated.
Current Settings
Point and
Press Select
Point to desired
Occupancy Sensor
Press ‘Select’
New Settings
Current Settings
Test Mode
Load Toggle
Recall Profile
HBP-111 Configuration
Press
Select
Choose
Current
Settings
Current Settings allow you to recall the parameters for a
specific sensor. These are read only parameters.
View Current Settings
Time Delay:
Sensitivity:
On Set point:
Burn-In Mode:
Walk-through:
Visual Alert:
SEND
<15 Mins>
<Max>
< Dis>
< Dis>
< Dis>
< Dis>
HBP-111 Settings
Press the Left/Right Arrow
to go to more settings
NEXT
Highlight and press
Select to view the current
settings.
Done
Service Mode: <Ena>
Light Level: <200>
PRIOR SAVE DONE
HBP-111 Settings
Press the Down Arrow
to Choose DONE
Save HBP-111 Parms
Save FSP-211 Parms
To be able to go to the
HBP-111 Home screen
go to DONE and press the
Select button.
In Service Mode, motion
detection is disabled. If
you enable Service Mode,
loads must be turned ON
and OFF manually. When
disabled (the default), the
sensor functions normally.
Light Level
Service Mode: <Dis>
Light Level: <200>
PRIOR SAVE DONE
HBP-111 Settings
Save HBP-111 Parms
Save FSP-211 Parms
Presents light level to the
HBP-111. The light level
reading can be used as
a reference for setpoint
adjustments.
To be able to Save
these Current Settings
parameters as one of the
profiles go to SAVE and
press the Select button.
To Save these New
Settings parameters as
one of the profiles go
to SAVE and press the
Select button.
Visit our web site for FAQs: www.wattstopper.com