Leica IC90 E - Pairing Cameras with Remotes

Leica IC90 E User Manual The Camera Remote Control (Standalone Kit) 38
Pairing Cameras With Remotes
Pairing

The LeicaIC90 E and the remote control
can be paired and then only respond
to each other. This can be helpful when using
multiple cameras and remote controls.
1. Press the button to start or end the
process.

In order to achieve successful pairing
and avoid pairing by mistake, the second
step must be performed within 4 seconds.

If a "timeout" is displayed after 4 seconds,
press the "Pair" button again to start the
process.
2. Press and hold the button on your remote
control representing the channel that you
want to assign to the connection (see
image to the right, channel selection) until
a corresponding confirmation is displayed
on the HD monitor. All of the buttons
except the button can be used for this.
3. The microscope only responds to the
remote control commands from the remote
control used for the pairing.
Resetting to factory setting
1. Press the button to start the process.
2. Press the button until a corresponding
confirmation is displayed on the HD monitor.
Leica IC90 E User Manual The Camera Remote Control (Standalone Kit) 38