45
Leica IP S
Operation 5
LED off:
• Printer disconnected from power supply.
Note
Printing is possible in POWER ON mode only.
To activate POWER ON with the printer being in STANDBY mode, press POWER. POWER ON will be
activated via the PC interface.
If no print job is received within a certain period of time, the printer automatically switches over to
STANDBY mode. After switching from STANDBY mode to POWER ON mode, there will be a reduced
print throughput until all systems have reached their proper operating temperature.
LOADED (→ "Fig. 38-5")
To confirm a magazine exchange
Pressing LOADED briefly:
• Informs the printer that an empty magazine has been refilled and put back into place. (Or that a
magazine has been removed and replaced by another one containing slides of a different color).
Pressing and holding LOADED for approx. 10 sec. in offline mode:
• Informs the printer that a cartridge has been exchanged (→ p. 36 – 4.9 Exchanging the transport
cartridge for an ink cartridge).
ONLINE (→ "Fig. 38-7")
Interrupting a print job in progress.
LED on:
Printer is ready and waiting for a new print job.
LED flashing:
• A data transmission is in progress or a print job is being carried out.
• Pressing ONLINE while a print job is in progress interrupts printing. The current print job, however,
is completed. The ONLINE LED goes out. At that point the printer can be accessed (e.g. to remove a
half-empty magazine and refill)
• To resume the previously interrupted print job, press ONLINE again. The ONLINE LED goes back on
or – if there are still print jobs that have not been completed – the LED starts flashing.
LED off:
• Printer is offline. No print jobs will be carried out until the printer is made ready (LED on).
To Next Page
Loading...
