Leica M Series User Manual Assembly 46
Leica IsoPro Motorized Mechanical Stage: Assembly (Continued)
Mechanical stage for X-Y stage control
module
1. Plug the CTL2 plug of the mechanical stage
motor into one of the three available CTL2
interfaces.
2. Plug the CTL2 plug of the Leica PSC control-
ler into another CTL2 interface.
O The third CTL2 interface is available for
connecting other instruments, such as the
Leica foot switch (10 447 398) or TL RCI
transmitted light base (10 446 352).
O The 15-pin Sub-D interface is intended for
use with the Leica SmartMove controller
(11 501 197).
3. Plug a power cable into the socket provided
and into a grounded power socket.
As soon as all instruments have been plugged
into the control box and it has been plugged
into the power supply, the mechanical stage
initializes and automatically drives to the mid
position.
4. Connect the PC (where applicable) and
X/Y Stage DCI Module (using a suitable
USBcable).
To Next Page
