4. OPERATION ADJUSTMENTS
Make sure that the PTO shaft is disengaged and the tractor engine is
switched off before adjustments are made.
4.1 Adjust the Tines
Procedure
1. Push the lock (1) down to disengage the lock and move the tine (2) to
the required position (Figure 14, page 4‑1). The lock engages
automatically.
• Use position (A) only for the outer rotor type to ted the side of the
field, to give a small spread of the crop and to make sure that the
crop stays on the field.
• Use position (B) for normal tedding.
1. Lock - 2. Tine - A. Small spread tedding - B. Normal tedding
Figure 14. Adjust the position of the tines
WARNING
Operation adjustments 4-1
T-H021.1301EN
To Next Page
Loading...
