4.2 Adjust the Height of the Rotor Wheels
Procedure
1. Move the Lotus to the headland position (page 3‑13).
2. Switch off the tractor engine.
3. Make sure the rotors can not move downwards.
4. Remove the pin from the wheel assembly.
5. Adjust the wheel assembly to the required height (Figure 15, page 4‑
2) position:
• Position A is used during transport to create a smaller transport
width.
• Position B is recommended when working with light and short
crops or windy conditions.
• Position C and D are the intermediate positions defined by the
operator.
• Position E is recommended when working with heavy and long
crops.
6. Install the pin in the required hole of the wheel assembly.
7. Secure the pin with the locking pin.
1. Pin - 2. Locking pin - A. Lowest height - B. Second lowest height - C. Middle height -
D. Second highest height - E. Highest height
Figure 15. Adjust the height of the rotor wheels
4-2
Operation adjustments
T-H021.1301EN
To Next Page
Loading...
