Lenovo ThinkServer RD240 - Position the RAID Controller Near the Riser Card Assembly. Ensure that the Left Edge of the RAID Controller; Straight down into the PCI Card Slot 1; RAID Controller

c.HoldthebatterycardassemblywiththebatterysideupandtheJ5board-to-boardconnector
liningupwiththeJ10BBUconnector1ontheRAIDcontroller.Carefullypressthebatterycard
assemblyontotheRAIDcontrollersothatthetwoconnectorsarermlyjoined.Then,securethe
batterycardassemblytotheRAIDcontrollerwiththethreescrewsandthestandoffsthatcome
withthebatterycardassemblyaccessorykit.
Figure42.InstallingthebatterycardassemblyontotheRAIDcontroller
1J10BBUconnector
6.ConnectoneendoftheminiSASsignalcabletotheRAIDcontroller.
Note:Usethetwo400mm(15.75inches)miniSASsignalcables.
Figure43.ConnectingtheminiSASsignalcablestotheRAIDcontroller
1Ports0-3
2Ports4-7
a.ForoneminiSASsignalcable,connecttheendtotheports0-3ontheRAIDcontroller.
b.FortheotherminiSASsignalcable,connecttheendtotheports4-7ontheRAIDcontroller.
7.PositiontheRAIDcontrollerneartherisercardassembly.EnsurethattheleftedgeoftheRAIDcontroller
isinsertedintothenotchoftheRAIDcardretentionbracket1,andthenrmlyinserttheRAIDcontroller
straightdownintothePCIcardslot12untilitissecurelyseated.Theninstallthescrew3tosecurethe
RAIDcontroller.
Chapter7.Installing,removing,orreplacinghardware67