18. In the “Provide your administrator information (account 2 of 2)” window, type your user name and
password, and then click Next.
19. In the “Keep your server up-to-date automatically” window, configure the settings as you need. Your
server will restart several times.
20. When the “Your server is now ready to use” window is displayed, click Close to complete the
installation.
Installing the Microsoft Windows Small Business Server 2011 Standard
operating system
This topic provides instructions on how to install the Microsoft Windows Small Business Server 2011
Standard operating system.
Note: Before you install this operating system, connect your server to the network.
To install the Microsoft Windows Small Business Server 2011 Standard operating system, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. If the message Press any key to boot from cd or DVD is displayed, press any key. If the message Windows
Setup [EMS Enabled] is displayed, press Enter. Wait several minutes for the system to load the files.
3. In the Installing Windows window, select the language and other options. Then, click Next.
4. Click Install now.
5. Read the license terms, select I accept the license terms, and click Next.
6. Select the type of installation as you need. The following steps are based on the scenario that Custom
(advanced) is selected in this step.
7. When the “Where do you want to install Windows” window is displayed, connect the USB storage
device that contains the driver to your server, and click Load Driver.
8. Browse to the folder where the driver is stored, and click OK. The “Select the driver to be installed”
window is displayed.
9. Select the driver you want to install and click Next.
10. In the “Where do you want to install Windows” window, click Drive options(advanced).
11. Select the hard disk drive on which you want to install the operating system and click New.
12. Type the amount of space (in MB), and then click Apply.
13. Ensure that the drive partition is correct and click Next. The installation begins.
Notes:
• The drive partition must be greater than 80 GB. It is recommended that the drive partition is greater
than 120 GB.
• Your server will restart several times during the installation.
14. In the Continue Installation window, select Clean Install. Then, click Next.
15. Click Open Date and Time to verify the clock and time zone settings to set your date and time, and
click OK. Then, click Next.
Note: If the server can identify the Ethernet card, go to Step 23.
16. When “A network adapter was not found” window is displayed, connect the USB storage device that
contains the driver for the Ethernet card to your server.
Chapter 3. Installing an operating system in legacy mode 17
To Next Page
Loading...
Need help?
General