Go back to the Partitioner window, the created root partition, boot partition, and swap partition are
displayed. Click Next. The drive partition is finished.
13. In the Format Warnings window, click Format to format the hard disk drive.
14. In the “Writing storage configuration to disk” window, click Write changes to disk.
15. In the “Boot loader operating system list” window, click Next.
16. The default installation is a basic server installation. You can customize your server by selecting a
different set of software from the software list or adding additional repositories that you want to use for
the software installation. Select Customize now. Then, click Next. The installation process begins.
Notes:
• If a warning window is displayed, select the option of your choice and then continue with the
installation.
• If you install the operating system in the UEFI mode, ensure that the tboot-1.7.4-1.el6.x86_64 -
Performs a verified launch using Intel TXT package is not selected.
17. After the installation is completed, click Reboot to restart your server.
Installing the Red Hat Enterprise Linux 7 operating system
This topic provides instructions on installing the Red Hat Enterprise Linux 7 (x64) operating system
To install the Red Hat Enterprise Linux 7 (x64) operating system, do the following:
1. Download the drivers from the Lenovo Web site. Unzip the drivers if necessary. Then, copy the drivers to
a USB storage device or burn the drivers to a disc.
2. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
3. Select Install Red Hat Enterprise Linux 7.0 and press Enter.
4. Select the language that you want to use during the installation process and click Continue.
5. Configure the date, time, language, and keyboard layout for the system.
6. In the INSTALLATION SUMMARY window, click SOFTWARE SELECTION, and then select the software
that you want to install.
Note: The following steps are based on the scenario that you select Server with GUI, select all of the
options on the right pane, and click Done.
7. In the INSTALLATION SUMMARY window, click INSTALLATION DESTINATION.
8. Select the drive partition on which you want to install the operating system. Then, click Done. If you
want to create a partition manually, do the following:
a. Select I will configure partitioning and then click Done.
b. In the Manual Partitionning window, select Standard Partition. Then, do one of the following to
create a partition and click Done.
• Manually create a root partition (/)
To create a root partition, do the following:
1) In the Manual Partitionning window, click + in the bottom left corner.
2) In the ADD A NEW MOUNT POINT window, select the forward slash (/) from the Mount Point
drop-down list box.
3) Type the amount of space (in MB) in the Desired Capacity field and then click Add mount
point.
28
ThinkServer RS140 Operating System Installation Guide
To Next Page
Loading...
