Note: In UEFI mode, in the Press any key to... window, press any key to start installing Red Hat
Enterprise Linux 6.7. In the GNU GRUB version 0.97 window, choose the option you need and press
Enter.
3. When the Disk Found window is displayed, select Skip and then press Enter.
4. In the RED HAT window, click Next.
5. Select the language that you want to use during the installation process and click Next.
6. Select the appropriate keyboard layout for the system and click Next.
7. Select the type of devices that are involved in the installation, and then click Next.
Note: If the Storage Device Warning window is displayed, click Yes, discard any data. If the message
displays as “At least one existing installation has been detected on your system. What would you like to
do?”, select the option as you desired and then click Next.
8. Type a name for your server. Then, click Next.
9. Specify your time zone by selecting the nearest city in your time zone. Then, click Next.
10. Personalize the server by typing the root password for the root user account. Then, click Next.
Note: If a message prompts you that the password is weak, click Use Anyway.
11. In the Which type of the installation would you like window, select your desired option and click Next.
The following steps are based on the scenario that Create Custom Layout is selected in this step. If the
Below are the storage devices window is displayed, move the RAID or hard disk in the Data Storage
Devices list to the Install Target Devices list in the right, and then click Next.
12. In the Please Select A Device window, do one of the following to create a partition and then click Next.
• Manually create a root partition (/)
To create a root partition, do the following:
a. Click Create. The Create Storage window is displayed.
b. Select Standard Partition and then click Create.
c. In the Add Partition window, select the forward slash (/) from the Mount Point drop-down list box.
d. Select Ext4 from the File System Type drop-down list box.
e. In the Allowable Drives window, select the hard disk drive on which you want to install the
operating system.
f. Type the amount of space (in MB) in the New Partitions Size window and then click OK.
• Manually create a boot partition (/boot in legacy mode) or (/boot/efi in UEFI mode)
To create a boot partition, do the following:
a. Click Create. The Create Storage window is displayed.
b. Select Standard Partition and then click Create.
c. In the Add Partition window, select /boot/ (or select (/boot/efi) in UEFI mode) from the Mount
Point drop-down list box.
d. Select Ex4 (or EFI System Partition in UEFI mode) from the File System Type drop-down list
box.
e. In the Allowable Drives window, select the hard disk drive on which you want to install the
operating system.
f. Type the amount of space (in MB) in the New Partitions Size window and then click OK.
• Manually create a swap partition
To create a swap partition, do the following:
a. Click Create. The Create Storage window is displayed.
Chapter 3. Installing an operating system in legacy mode 23
To Next Page
Loading...
