Lenovo ThinkServer TS130 - Selecting a Startup Device; Selecting or Changing the Startup Device Sequence; Configuring RAID

Table10.SubmenusundertheATADriveSetupmenu(continued)
ItemOptionDescription
HardDiskPre-delay
[Disabled]/3Seconds/6Seconds/9
Seconds/12Seconds/15Seconds
/21Seconds/30Seconds
ForcetheBIOStodelaythe
initializationofharddiskdrivesforup
to30seconds.Thedelayprovides
yourharddiskdrivesmoretimeto
spinupbeforetheBIOSinitializes
them.
Note:[]indicatesthedefaultsetting.
Table11.SubmenusundertheVideoSetupmenu
ItemOptionDescription
SelectActiveVideoIGD/PEG/PCI/[Auto]Selecttheprimaryvideodevicethat
willbeusedforgraphicoutput.Ifyou
selectAuto,thesystemwillprioritize
videodevicesinthefollowing
sequence:PEG(PCI-eGraphics
Device),PCI(PCIGraphicsDevice),
andIGD(InternalGraphicsDevice).
Notes:WhenyouselectIGD,the
followingitemswillbehidden:
•Pre-AllocatedMemorySize
•TotalGraphicsMemory
•Multi-MonitorSupport
Pre-AllocatedMemorySize32MB/64MB/[128MB]MemoryallocatedtoIGD.
TotalGraphicsMemory128MB/256MB/[Maximum]
Totalmemoryallocatedtographics
devices.
Note:Thisfunctionworksonly
whenyouareusingtheWindowsXP
operatingsystemonyourserver.
Multi-MonitorSupportEnabled/[Disabled]
Enableordisablethemulti-monitor
supportfunction.
Note:[]indicatesthedefaultsetting.
Table12.SubmenusundertheAudioSetupmenu
ItemOptionDescription
OnboardAudioController[Enabled]/Disabled
Enableordisabletheonboardaudio
controller.
Note:[]indicatesthedefaultsetting.
Chapter6.Conguringtheserver59