28
Removing the riser 1 module
Removing the riser 2 module
To reinstall, reverse the steps above.
2.2.9 PCIe card and riser card replacement
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
To remove a PCIe card on riser module, do the following:
1. Turn off all attached devices and the server.
2. Disconnect the ac power cord from the electrical outlet.
3. Remove the top cover. See "2.2.3 Top cover replacement".
4. Remove the riser assembly. See "2.2.8 Riser assembly replacement".
5. Rotate the latch (Step 1).
6. Pull the PCIe card outwards carefully to remove it (Step 2).
7. Unscrew the screws of riser card and remove the riser card from the PCIe riser cage.
To Next Page
Loading...
