30
To remove, reverse the steps above.
2.2.11 Hot-swap-drive dummy tray replacement
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
To remove the dummy tray for a 3.5-inch hot-swap drive, do the following:
1. Grab the handle of the dummy tray.
2. Pull the 3.5-inch dummy tray out of the chassis.
Grab the handle of the 3.5-inch dummy tray
To reinstall, reverse the steps above.
2.2.12 Hot-swap drive replacement
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
To remove a 3.5-inch hot-swap drive, do the following:
1. Gently push the release latch of the hot-swap drive to open the handle of the drive.
Pushing the release latch of a 3.5-inch hot-swap drive
To Next Page
Loading...
