• Youtube: Removing the security bezel
• Youku: Removing the security bezel
Step 1. Use the key to unlock the security bezel to the open position.
Figure 111. Unlocking the security bezel
Step 2. Press the release latch and pivot the security bezel outward to remove it from the chassis.
Figure 112. Security bezel removal
Install the security bezel
Install the security bezel by pivoting the security bezel inward until the other side clicks into place, and then
locking the security bezel.
Before installing the security bezel:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 51).
2. Watch the procedure. A video of this procedure is available from the following links:
• https://www.youtube.com/playlist?list=PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
• http://list.youku.com/albumlist/show/id_50483449
3. If you have removed the rack handles, reinstall it (see ThinkSystem SR850 Rack Installtion Guide).
To install the security bezel, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: Installing the security bezel
• Youku: Installing the security bezel
Step 1. Carefully insert the tabs on the security bezel into the slots on the right rack handle. Then, press
and hold the release latch, and pivot the security bezel inward until the other side clicks into place.
Chapter 3. Hardware replacement procedures 115
To Next Page
Loading...
