Table 6. Options available on the front operator panel (continued)
• XX is the temperature.
• YYY is the AC voltage.
• ZZ is the wattage.
Actions Actions provides the following available actions, which come in effect by pressing and
holding on the select button for three seconds:
• Restore XCC default settings is displayed as following:
RESTORE XCC DEFAULTS?
HOLD v FOR 3s
• Restart XCC is displayed as following:
REQUEST XCC HARD RESET?
HOLD v FOR 3s
• Request XCC physical presence is displayed as following:
REQUEST XCC PHY. PRES.?
HOLD v FOR 3s
• Clear CMOS is displayed as following:
CLEAR CMOS?
HOLD v FOR 3s
Note: This action is only available when the system power is off.
• System reboot is displayed as following:
SYSTEM RESET BUTTOM?
HOLD v FOR 3s
Rear view
This section contains information about the LEDs and connectors on the rear of the server.
The following illustrations show the connectors and LEDs on the rear of the server.
Figure 10. Rear view
Table 7. Components on the server rear view
1 PCIe slots (slot 1-2, 8-11) 10 System error LED (yellow)
2 PCIe riser-card (slot 3-5)
11 Identification button
Chapter 2. Server components 17
To Next Page
Loading...
