Step 2. Disconnect USB cables and front operator panel cable from the system board.
Note: Make sure the USB 3.0 connector stays vertical when being removed from the system board.
Figure 76. Removing USB 3.0 connector vertically
Step 3. Remove the USB 3.0 cable from the cable guide.
Step 4. Remove the screw that secures the tray assembly.
Step 5. Grasp the tab on the rear of the tray assembly, and push it out from the server.
Figure 77. Operator panel tray assembly removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the operator panel tray assembly
Use this procedure to install the operator panel tray assembly.
Before installing the operator panel tray assembly:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 51).
Chapter 3. Hardware replacement procedures 83
To Next Page
Loading...
