Remove a hot-swap fan
Use this procedure to remove a hot-swap fan.
S017
CAUTION:
Hazardous moving fan blades nearby.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Before removing a hot-swap-fan:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 51).
2. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
3. Watch the procedure. A video of this procedure is available from the following links:
• https://www.youtube.com/playlist?list=PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
• http://list.youku.com/albumlist/show/id_50483449
4. Remove the top cover (see “Remove the top cover” on page 130).
To remove a hot-swap-fan, complete the following steps:
Step 1. Pinch on the top of the fan, and press on the latch to release the fan from the connector.
64
ThinkSystem SR850 Maintenance Manual
To Next Page
Loading...
