Step 3. Tighten screw 1 and 2 first, then tighten screw 3 and 4.
a. Partially tighten screw 1.
b. Fully tighten screw 2.
c. Fully tighten screw 1.
d. Partially tighten screw 3.
e. Fully tighten screw 4.
f. Fully tighten screw 3.
Note: Do not touch the thermal grease while handling the heat sink and fan module.
Tightening the screws on the heat sink and fan module for processor with TDP lower than
95W
Figure 75. Tightening the screws on the heat sink and fan module for processor with TDP lower than 95W
Tightening the screws on the heat sink and fan module for processor with 95W TDP
Chapter 3. Hardware replacement procedures 97
To Next Page
Loading...
