Figure 76. Tightening the screws on the heat sink and fan module for processor with 95W TDP
Step 4. If the server is installed with processor with 95W TDP, the heat sink fan should be installed on the
rear side of the chassis. Align the four fan screws to the screw holes on the rear side of the chassis,
and fasten the screws to secure it.
Figure 77. Installing the heat sink fan to the rear of the chassis
Step 5. Connect the heat sink fan cable to the system board, see
“Internal cable routing” on page 19.
98 ThinkSystem ST50 V2 Maintenance Manual
To Next Page
Loading...
