Lenovo ThinkSystem ST550 - Install the Pcie Adapter Retainer

To install the PCIe adapter holder, complete the following steps:
Figure 61. PCIe adapter holder installation
Step 1. Insert the PCIe-adapter-holder post into the corresponding recess in the chassis.
Step 2. Secure the three notches on the PCIe adapter holder with the three mounting studs on the chassis.
Step 3. Secure the PCIe-adapter-holder tab with the corresponding hole in the chassis.
Install the PCIe adapter retainer
Use this information to install the PCIe adapter retainer.
“Read the
installation
Guidelines” on
page 58
“Power off
the server
for this task”
on page 109
To install the PCIe adapter retainer, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku: http://list.youku.com/albumlist/show/id_50483452
Chapter 3. Server hardware setup 99