Install the foot stands
Use this information to install the foot stands.
“Read the
installation
Guidelines” on
page 58
To install the foot stands, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku: http://list.youku.com/albumlist/show/id_50483452
Step 1. Lay the server on its side for easier operation.
Step 2. For each foot stand, carefully insert the two tabs on the foot stand into the corresponding holes in
the chassis. Then, pivot the foot stand inward until the other side clicks into place.
Figure 66. Foot stand installation
Important: To help the server stand steadily, ensure that the foot stands are installed outward as
shown in “Front view” on page 15.
Install a simple-swap drive
Use this information to install a simple-swap drive.
“Read the
installation
Guidelines” on
page 58
“Power off
the server for
this task” on
page 109
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 59
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• For a complete list of supported optional devices for the server, see:
http://www.lenovo.com/us/en/serverproven/
• The drive bays are numbered to indicate the installation order (starting from number “0”). Follow the
installation order when you install a drive. See “Front view” on page 15.
104
ThinkSystem ST550 Setup Guide
To Next Page
Loading...
