Lenovo ThinkSystem ST550 - Install the Server Cover

Step 1. Touch the static-protective package that contains the new RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the new RAID super capacitor module
out of the package and place it on a static-protective surface.
Step 2. Insert one end of the RAID super capacitor module into the slot of the air baffle. Then, press down
the other end of the RAID super capacitor module until it snaps in place.
Figure 64. RAID super capacitor module installation
Step 3. Connect the RAID super capacitor module to the extension cable.
Install the server cover
Use this information to install the server cover.
“Read the
installation
Guidelines” on
page 58
“Power off
the server for
this task” on
page 109
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 59
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
102
ThinkSystem ST550 Setup Guide