Lenovo ThinkSystem ST550 - Install a Simple-Swap-Drive Backplate

After installing the expansion drive cage, ensure that:
• The signal cables are secured by the clips
1 .
• The signal cables are bound correctly by the Velcro strap shipped in the package.
Figure 43. Securing and binding the signal cables correctly
Install a simple-swap-drive backplate
Use this information to install a simple-swap-drive backplate.
“Read the
installation
Guidelines” on
page 58
“Power off
the server for
this task” on
page 109
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 59
Before installing the simple-swap-drive backplate, touch the static-protective package that contains the new
backplate to any unpainted surface on the outside of the server. Then, take the new backplate out of the
package and place it on a static-protective surface.
To install the simple-swap-drive backplate, complete the following steps:
Step 1. Note the orientation of the new simple-swap-drive backplate.
Chapter 3. Server hardware setup 79