a. Remove the front bezel and then remove the cover of the drive bay filler from the front bezel.
Figure 37. Drive-bay-filler cover removal
b. Remove the drive bay filler out of the chassis.
Figure 38. Drive bay filler removal
2. Touch the static-protective package that contains the new optical drive or tape drive to any unpainted
surface on the outside of the server. Then, take the new optical drive or tape drive out of the package
and place it on a static-protective surface.
To install an optical drive or a tape drive, complete the following steps:
76
ThinkSystem ST550 Setup Guide
To Next Page
Loading...
