Note: The following illustrations are based on the scenario that you install an optical drive. The procedure is
similar for installing a tape drive.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. If necessary, remove the cover of the drive bay filler from the front bezel.
Figure 52. Drive bay filler cover installation
a. Push the tab on the front bezel to release the cover of the drive bay filler.
b.
Remove the cover of the drive bay filler as shown.
Step 2. If necessary, remove the drive bay filler out of the chassis.
Chapter 4. Server hardware setup 99
To Next Page
Loading...
