Note: For some M.2 adapters that support two identical M.2 drives, install the M.2 drive in slot 0 first.
Figure 78. M.2 drive slot
Table 41. M.2 drive slot locations on M.2 boot adapter
1 M.2 boot adapter slot 0 2 M.2 boot adapter slot 1
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Install the M.2 drive
Figure 79. M.2 drive installation
a.
Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
b.
Pivot the M.2 drive down until the notch catches on the lip of the retainer.
c.
Slide the retainer forward (towards the connector) to secure the M.2 drive into place.
Install the intrusion switch
Use this information to install the intrusion switch.
About this task
S002
Chapter 4. Server hardware setup 123
To Next Page
Loading...
