Figure 59. Installing slim optical drive into the drive bay adapter
a. Slide the slim optical drive into the adapter.
b.
Secure the slim optical drive with two screws.
Step 4. Hold the 5.25-inch drive bay adapter assembly in the correct orientation; then, slide it into the drive
bay until it snaps into position.
Figure 60. Optical drive installation
Step 5. Connect the power cable and the signal cable to the rear of the 5.25-inch drive bay adapter
assembly. For more information about the cable routing. See “Optical drive cable routing” on page
52.
Install a 2.5-inch hot-swap drive backplane
Use this information to install a 2.5-inch hot-swap drive backplane.
About this task
S002
104 ThinkSystem ST650 V2 Setup Guide
To Next Page
Loading...
