• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Remove the NVLink covers.
Figure 86. NVLink covers removal
Step 2. Note the orientation of the NVLink bridge; then, install the NVLink bridge as shown.
132
ThinkSystem ST650 V2 Setup Guide
To Next Page
Loading...
