6 Information SET-01
11.7 Erasing a completed MU 42
11.8 Error messages in multi-unit consists 42
12 Throwing turnouts and setting signals 43
12.1 Feedback and display of the turnout position 44
12.2 Train operation while controlling turnouts or signals 45
13 Displaying feedback 46
14 Reading/Changing decoder settings 47
14.1 What is programming and what purpose does it serve? 47
14.2 Programming on the Main - PoM 50
14.3 Programming on the Programming track 54
14.4 Error messages during programming 65
15 Configuring the LH100 handheld using the SYS menu 66
15.1 SYS_0: entering the XpressNet device address 66
15.2 SYS_1: the system menu 67
15.3 SYS_7: Displaying the command station ID 74
15.4 SYS_8: Displaying the version number of the command station 74
15.5 SYS_9: Displaying the version number of LH100 75
16 Expanding SET-01 76
16.1 Adding XpressNet to allow additional input devices 77
16.2 More power through more power stations 78
17 Technical appendix 80
17.1 Error messages on the display 80
17.2 The LZ100 locomotive database 82
17.3 LZ100 Reset 82
17.4 Selecting suitable transformers for Set-01 82
17.5 Power Station LV101 83
17.6 Advice on the wiring of the model railway 88
17.7 Mixed operation: conventional DC and digital DCC 90
17.8 Wiring the XpressNet Data Network 91
17.9 Bits and bytes - Conversion calculation help 93
17.10 Glossary 94
18 Troubleshooting Guide 96
19 Radio And Television Interference 98
20 North American Warranty 99
To Next Page
Loading...