26 Information SET-01
7.7 Showing and changing throttle-notches
In this section you learn:
- what throttle-notches are
- which throttle-notches are available to you
- how to select different throttle-notches for individual locomotive
addresses.
The area from stopped to maximum speed of a locomotive is divided
into a series of throttle-notches. The more notches present, the
smaller the division between different locomotive speeds. With the
LH100 you can set the displayed locomotive address to have 14, 27,
28 or 128 throttle-notches.
This is how you show/change the speed step modes:
Press On the display you see Explanation
Call up the locomotive address
whose number of throttle-notches
you want to see or change. Make
sure that the locomotive is on
speed 0; if needed press the '<>'
key.
After pressing the ‘+’ key the
current number of LH100 throttle-
notches is shown. 28 throttle-
notches is the default for version
3.0
By repeated pressing of the ‘+’
key you are now shown the
possible throttle-notches that are
available.
To assign a desired number of
throttle-notches to this locomotive
address, press ‘Enter’.
FF If the locomotive's speed is not 0, then the currently set
number of throttle notches is shown as long as you keep the
‘+’ key pressed, but the mode cannot be changed.
To Next Page
Loading...
Need help?
General
