Information SET-01 81
DIGITAL plus
ERR 26 DH/MU One of the locomotives is already part of another MU/double
header.
ERR 27 DH/MU One of the two locomotives was not at throttle position 0.
Locomotives must be stopped before you can combine them
into a consist.
ERR 30 Command
station
stack
It is not possible to erase locomotive from command station
stack.
ERR 31 Command
station
stack
The Command station stack is full. You must remove a
locomotive address before you can add another address.
ERR 96 Your LH100 is not able to create a data connection over XpressNet
Check if the connection of your LH100 to XpressNet was correctly
made. The XpressNet wires A and B may have been switched.
The wrong XpressNet address is set. Please note that you have to set
an address supported by the command station in use. Unplug the
handheld and then plug it back in with the 'St' key pressed and the
current addresses will be displayed and can be changed.
ERR 97 There is an error in the data processing in command station LZ100. All
information about speed, direction and extra functions of the
locomotives, as well as the status of turnouts and feedback encoders
has been erased. The most frequent cause of this is an improper
power supply to the LZ100. If this error appears repeatedly, the battery
in LZ100 may be dead. This battery ensures that the data is stored even
after the power to the command station is turned off. Please contact
your model railroad dealer or Lenz Elektronik for replacement.
ERR 98 The command sent from the hand held controller to the command station
is not present in its list of commands. The cause is generally a software
version in the command station that does not understand this command.
Typical example
You are trying to assemble a multi-unit consist, but have connected your
hand held controller LH100 to a command station version 2.0 which does
not support this feature.
ERR 99 General system error. The hand held controller did not receive the
expected reply to a question or command to the command station. The
cause may be interference on the XpressNet. Please check if all wires
are connected correctly. If this does not correct the problem it is
possible that the command station or the hand held controller is
defective. Please contact your model railroad dealer or Lenz Elektronik.
To Next Page
Loading...
Need help?
General
