Lenze c550 - Switch-Off Behavior; Retain Variables and Persistent Variables

9.3 Reset controller
To reset the device, press the reset buon. 4Features ^ 12
How to perform the reset:
1. Press and hold the reset buon for approx. 1 s.
The LEDs are o.
Aer the reset, the "RUN" LED lights up in green.
Relevant parameters of other funcons
Address Name Default seng Seng range
0x2022:001 Device commands: Load default sengs O / ready [0] Selecon list
0x2022:039 Device commands: Load TA default sengs O/Ready [0] Selecon list
No retain data is stored if the reset buon is used to reset the device.
4Features ^ 12
4Reset parameters to default ^ 23
Device funcons
Reset controller
82