Lenze E84DGFCRFNP - Page 13

Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23 13
3 Product description
3.2 Features and variants
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• The PROFINET Communication Unit is ...
• mounted on top of the Wiring Unit (E84DGVNxx);
• supplied internally via the Drive Unit (E84DGDVxxxxxxxx) or externally via a separate
voltage source.
• The I/O connections can be brought into the device via M12 connectors or cable glands.
• Devices without an integrated safety system (safety option) have no analog input and no relay
output.
• The integrated safety system can be used on machines for the protection of persons.
• Support of the I&M0...4 functionality for the identification of the standard device
• Automatic detection of the baud rate 100 Mbps
• A line topology is enabled by the integrated 2-port switch.
• Protocols supported:
• LLDP (Link Layer Discovery Protocol) for topology recognition
• SNMP (Simple Network Management Protocol) for diagnostics
• MRP (Media Redundancy Protocol) for the implementation of the inverter into a ring
topology as client node
• Exchange of up to 8 process data words per direction
• Communication with the Lenze »Engineer« (access to all Lenze parameters) is executed via the
diagnostic interface of the Drive Unit.
• An online connection via PROFINET can be established using the Lenze »Engineer«.
 "Inverter Drives 8400 motec" hardware manual
Here you will find detailed information on the integrated safety system (safety option).
Reference manual/online help for the Inverter Drive 8400 motec
Here you will find detailed information on how to configure the safety system (safety
option).