Lenze ECSES Series - Page 125

Commissioning
Configuring the digital inputs and outputs
Change of the terminal assignment
6

125
EDBCSXS064 EN 4.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
For possible signals see "selection list − digital
signals"
 428
[C7511] Selection of the signal source for
the digital input signals of the
"Torque" function block
1 TorqueIn−dig 1000 0 (FALSE, not assigned) CW rotation (TORQUE−RLQ.Cw)
 350
2 TorqueIn−dig 1000 0 (FALSE, not assigned) CCW rotation
(TORQUE−RLQ.CCw)
3 TorqueIn−dig 1000 0 (FALSE, not assigned) Setting of the torque setpoint
integrator to 0 along the
adjusted ramps
(TORQUE−NSET.Rfg0)
 351
4 TorqueIn−dig 1000 0 (FALSE, not assigned) Activation of the motor holding
brake (TORQUE−BRK.SetBrake)
 360
5 TorqueIn−dig 1000 0 (FALSE, not assigned) Setting of quick stop
(TORQUE−QSP.Set1)
 354
6 TorqueIn−dig 1000 0 (FALSE, not assigned) Setting of quick stop
(TORQUE−QSP.Set2)
7 TorqueIn−dig 1000 0 (FALSE, not assigned) Source for the integral−action
component of the controller
(TORQUE−MCTRL.ILoad)
8 TorqueIn−dig 1000 0 (FALSE, not assigned) Keeping (freezing) the torque
setpoint integrator to the current
value (TORQUE-NSET.RfgStop)
9 TorqueIn−dig 1000 0 (FALSE, not assigned) Inversion of additional torque
setpoint (TORQUE−MAddInv)
For possible signals see "selection list − digital
signals"
 428