Lenze ECSES Series - Page 323

Function library
Speed (speed control)
12

323
EDBCSXS064 EN 4.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
20 SpeedIn−dig 1000 0 (FALSE, not assigned) Inversion of additional torque
setpoint (SPEED−MAddInv)
For possible signals see "selection list − digital
signals"
 428
C7430 Display of the current signal
states on the analog input of the
"Speed" function block
−32768
(= −100 %)
{1} 32767
(= 100 %)
1 Speed−an Speed setpoint
(SPEED−NSET.NSet)
 326
2 Speed−an Additional speed setpoint
(SPEED−NSET.NAdd)
3 Speed−an Lower torque limit
(SPEED-MCTRL.negLoMLim)
 332
4 Speed−an Upper torque limit
(SPEED-MCTRL.HiMLim)
5 Speed−an Additional torque setpoint
(SPEED-MCTRL.MAdd)
6 Speed−an Manual field weakening
(SPEED−MCTRL.FldWeak)
7 Speed−an Manual adaptation of the
proportional gain of the speed
controller
(SPEED−MCTRL.NAdapt)
8 Speed−an Manual adaptation of the
integral−action component of the
speed controller
(SPEED−MCTRL.ISet)
9 Speed−an Speed threshold for the motor
holding brake
(SPEED-BRK.SpeedThreshold)
 340
10 Speed−an Direction of torque created by
the drive against the motor
holding brake (SPEED−BRK.Sign)
11 Speed−an Manual adaptation of the phase
controller (SPEED−MCTRL.PAdapt)
 332
12 Speed−an Limit value for influencing the
phase controller
(SPEED−MCTRL.PosLim)
13 Speed−an Lower speed limit for speed
limitation
(SPEED−MCTRL.NStartMLim)