EasyManua.ls Logo

Lenze ECSES Series - Page 324

Lenze ECSES Series
484 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Function library
Speed (speed control)
12
324
EDBCSXS064 EN 4.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
[C7431] Selection of the signal source for
the analog input signals of the
"Speed" function block
1 SpeedIn−anl 1000 FIXED 0 % (not assigned) Speed setpoint
(SPEED−NSET.NSet)
326
2 SpeedIn−anl 1000 FIXED 0 % (not assigned) Additional speed setpoint
(SPEED−NSET.NAdd)
3 SpeedIn−anl 1000 FIXED 0 % (not assigned) Lower torque limit
(SPEED-MCTRL.negLoMLim)
332
4 SpeedIn−anl 1000 FIXED 0 % (not assigned) Upper torque limit
(SPEED-MCTRL.HiMLim)
5 SpeedIn−anl 1000 FIXED 0 % (not assigned) Additional torque setpoint
(SPEED-MCTRL.MAdd)
6 SpeedIn−anl 1000 FIXED 0 % (not assigned) Manual field weakening
(SPEED−MCTRL.FldWeak)
7 SpeedIn−anl 1000 FIXED 0 % (not assigned) Manual adaptation of the
proportional gain of the speed
controller
(SPEED−MCTRL.NAdapt)
8 SpeedIn−anl 1000 FIXED 0 % (not assigned) Manual adaptation of the
Integral−action component of the
speed controller
(SPEED−MCTRL.ISet)
9 SpeedIn−anl 1000 FIXED 0 % (not assigned) Speed threshold for the motor
holding brake
(SPEED-BRK.SpeedThreshold)
340
10 SpeedIn−anl 1000 FIXED 0 % (not assigned) Direction of torque created by
the drive against the motor
holding brake (SPEED−BRK.Sign)
11 SpeedIn−anl 1000 FIXED 0 % (not assigned) Manual adaptation of the phase
controller (SPEED−MCTRL.PAdapt)
332
12 SpeedIn−anl 1000 FIXED 0 % (not assigned) Limit value for influencing the
phase controller
(SPEED−MCTRL.PosLim)
13 SpeedIn−anl 1000 FIXED 0 % (not assigned) Lower speed limit for speed
limitation
(SPEED−MCTRL.NStartMLim)
For possible signals see "selection list − analog
signals"
437
C7450 Speed−phi
Display of the setpoint for the
phase controller in the "Speed"
function block (speed
controlSPEED−MCTRL.PosSet)
332
−2147483647 {1} 2147483647
[C7451] SpeedIn−phi 1000
Setpoint for the phase controller
in the "Speed" function block
(SPEED−MCTRL.PosSet)
332
FIXED 0 (not assigned)
For possible signals see "selection list − phase
signals"
440

Table of Contents

Other manuals for Lenze ECSES Series

Related product manuals