Lenze ECSES Series - Page 370

Appendix
Code table
13

370
EDBCSXS064 EN 4.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
[C0095] Rotor pos adj 0
Activation of rotor position
adjustment for automatic
determination of the rotor
displacement angle.
C0058 displays the determined
rotor displacement angle (offset
angle).
 151
0 Inactive
1 Active
C0096 Extended password protection
for bus systems with activated
password (C0094)
All codes in the user menu can be
accessed.
1 AIF/CAN prot. 0 No access protection AIF access protection
2 AIF/CAN prot. 0 No access protection CAN access protection
0 No access protection Full access
1 Read protection Reading not possible
2 Write protection Writing not possible
3 Read/write protection Reading and writing not possible
C0097 DIS:Lt−Ident 0 Power stage identification
0 {1} 255
C0098 Set position 0
Home position of encoder
−2147483647 {1 inc} 2147483647
C0099 S/W version
Firmware version
Read only
0,0 {0,1} 25,5
C0101 15 additional acceleration times
for the speed setpoint.
Can be retrieved via digital
signals SPEED−NSET.TIx.
 327
1 add Tir 0.000
0.000 {0.001 s} 999.999 Relating to speed variation
0 rpm ... n
max
(C0011)
2 add Tir 0.000
... add Tir 0.000
14 add Tir 0.000
15 add Tir 0.000
C0103 add Tif 15 additional deceleration times
for the speed setpoint.
Can be retrieved via digital
signals SPEED−NSET.TIx.
 327
1 add Tif 0.000
0.000 {0.001 s} 999.999 Relating to speed variation
0 rpm ... n
max
(C0011)
2 add Tif 0.000
... 0.000
14 add Tif 0.000
15 add Tif 0.000
C0105 QSP Tif 0.0
Deceleration time for quick stop
(QSP)
 297
 144
0.000 {0.001 s} 999.999 Relating to speed variation n
max
(C0011) ...0 rev./min.