What to do if there is a current overload of the motor > C0127 in Lenze Control Unit?
If the Lenze Control Unit motor experiences a current overload exceeding C0127, possibly due to frequent or prolonged acceleration phases, check the drive dimensioning and the setting of C0127.
Why Lenze Control Unit motor rotates CCW when viewed to the motor shaft?
If the Lenze Control Unit motor rotates CCW when viewed to the motor shaft, the feedback system is not connected in the correct phase relation. Connect the feedback system in the correct phase relation.
Why Lenze ECSES Control Unit motor blocks in certain positions?
If the Lenze Control Unit motor blocks in certain positions, the number of pole pairs of the resolver or motor may not be set correctly. Ensure that the number of pole pairs (C0080) is set correctly.
General| Category | Control Unit |
|---|---|
| Manufacturer | Lenze |
| Input Voltage | 24 VDC |
| Protection Class | IP20 |
| Product Series | ECSES |
| Type | Controller |
| Operating Temperature Range | 0°C to +55°C |
| Storage Temperature Range | -25°C to +70°C |
| Communication Interfaces | Ethernet, CAN |
| Mounting | DIN Rail |
To Next Page
