Lenze EPM-H502 - Status Messages of the Operating Unit

Commissioning
Status messages of the operating unit
5

73
EDBPM−H502 DE/EN/FR 5.1
5.3 Status messages of the operating unit
The operating unit status can be queried any time. Information can be obtained
about
ƒ the interface (Port)
ƒ the name of the loaded driver (Driver)
ƒ the version of the loaded driver (Ver)
ƒ the network address of the operating unit (Addr)
ƒ the last error (Error)
You want to ... Touch the fields ... Example
A query the status of the operating unit.
1. Briefly touch the display in one of the
corners , ,  or .
– Note: This corner must not contain
a selectable field.
2. Immediately touch the diagonally
opposite corner for a moment.
0
1
2
3
B switch between the status displays of
different ports.
l E.g. between CAN port and ASP port
l Status messages are only displayed
for assigned/used ports
Port : NET
Driver : CAN Lenze M
Ver : X.XX
Addr : NO ADDRESS
Error : RESET
PROG
ESC
TRANS
PAGE
C close the status display.
ESC
Port : NET
Driver : CAN Lenze M
Ver : X.XX
Addr : NO ADDRESS
Error : RESET
PROG
ESC
TRANS
PAGE