Leuze electronic MLC 520 EX Series User Manual

Technical data
Leuze electronic MLC 530 85
Table 14.4: System data - transmitter
Table 14.5: System data receiver, indication signals and control signals
Table 14.6: Technical data of the electronic safety-related switching outputs (OSSDs) on the receiver
Relative humidity (non- condensing) 0 … 95 %
Vibration fatigue limit 5 g, 10 - 55 Hz in accordance with IEC/
EN 60068-2-6; amplitude 0.35 mm
Shock resistance 10 g, 16 ms in accordance with IEC/
EN 60068-2-6
Profile cross-section 29 mm x 35.4 mm
Dimensions see figure 14.1 and see table 14.7
Weight see table 14.7
Transmitter diodes, class in accordance with EN 60825-1:
1994 + A1: 2002 + A2: 2001
1
Wavelength 940 nm
Pulse duration 800 ns
Pulse pause 1.9
s (min.)
Mean power <50
W
Input current pin 4 (range) Against +24 V: 10 mA
Against 0 V: 10 mA
Pin Signal Type Electrical data
1 RES/STATE Input:
Output:
Against +24 V: 10 mA
Against 0 V: 0.3 mA
3, 4, 8 Depending on the operating
mode
Input: Against 0 V: 4 mA
Against +24 V: 4 mA
Safety-related PNP transistor outputs (short-circuit
monitored, cross-circuit monitored)
Minimum Typical Maximum
Switching voltage high active (U
v
- 1.5V) 18 V 22.5 V 27 V
Switching voltage low 0 V +2.5 V
Switching current 300 mA 380 mA
Residual current < 2
 200 A
a)
Load capacity 0.3 F
Load inductivity 2 H
Permissible wire resistance for load <200

b)
Permissible wire cross section 0.25 mm
2
Permissible cable length between receiver and load 100 m

Leuze electronic MLC 520 EX Series Specifications

General

Brand	Leuze electronic
Model	MLC 520 EX Series
Category	Lighting Equipment
Language	English