LEVC VN5 2021 - Crash Structures and Parking Sensors; Drill Zones and Passenger Compartment

Body and Paint
2
S023074 PA1
2020-05-12
19
Body
Body Structure - General Information
CAUTION
Before you drill into the vehicle, you must examine the Drill Zones,
page 20
document. This will help you to avoid damage to other components.
When you do the conversion:
– Do not damage the structural integrity of the vehicle.
– Do not drill into closed sections or extrusions
– Make sure that the weight of the additional components added is distributed evenly.
– All fasteners installed through the floor, side or roof must be sealed to prevent water ingress.
Use an LEVC approved sealant.
Welding
CAUTION
Do not weld the vehicle structure. The aluminum structure is riveted and bonded.
Heat from welding will damage the adhesive.
Cooling and air intakes
Do not install components that will decrease the air flow through the front grilles 3. If you
decrease the air flow it will cause the vehicle to over heat and restrict the engines air intake 2.
Do not install components that will decrease air flow through the cowl vent screen 1. If you
decrease the air flow it will reduce the performance of the climate control system.